K108 Active Noise Cancellation Module X2 (UQ3+NKC)

2022 Chevrolet Camaro ZL1, 2D Convertible, Standard TransSECTION K108 Active Noise Cancellation Module X2 (UQ3+NKC)
GM4332214Courtesy of GENERAL MOTORS COMPANY
Connector Part Information
  • Harness Type:Body Wiring Harness
  • OEM Connector: 13591061
  • Service Connector: 13591061
  • Description: 16-Way F 1.5 OCS Series (BK)
Terminal Part Information

Terminal Type ID Terminated Lead Diagnostic Test Probe Terminal Removal Tool
I 84757974 J-35616-2A (GY) J-38125-215A
Pin Size Color Circuit Function Terminal Type ID Option
1 0.75 BU 511 Left Front Low Level Audio Signal I IOS+NKC+UQ3
2 0.75 YE 512 Right Front Low Level Audio Signal I IOS+NKC+UQ3
3 0.75 GN/BK 599 Left Rear Low Level Audio Signal I IOS+NKC+UQ3
4 0.75 BN/WH 546 Right Rear Low Level Audio Signal I IOS+NKC+UQ3
5 0.75 BU 201 Left Front Speaker 1 [+] Control I IOS+NKC+UQ3
6 0.75 YE 200 Right Front Speaker 1 [+] Control I IOS+NKC+UQ3
7 0.75 GN 199 Left Rear Speaker [+] Control I IOS+NKC+UQ3
8 0.75 WH 46 Right Rear Speaker [+] Control I IOS+NKC+UQ3
9 0.75 BN/BU 1947 Left Front Low Level Audio [-] Signal I IOS+NKC+UQ3
10 0.75 BU/BN 1546 Front Low Level Audio [-] Signal I IOS+NKC+UQ3
11 0.75 BN/VT 1999 Left Rear Low Level Audio [-] Signal I IOS+NKC+UQ3
12 0.75 BU/BK 1946 Right Rear Low Level Audio [-] Signal I IOS+NKC+UQ3
13 0.75 BN/BU 118 Left Front Speaker [-] Control 1 I IOS+NKC+UQ3
14 0.75 YE/BK 117 Right Front Speaker [-] Control 1 I IOS+NKC+UQ3
15 0.75 GN/BK 116 Left Rear Speaker [-] Control I IOS+NKC+UQ3
16 0.75 BU/BK 115 Right Rear Speaker [-] Control I IOS+NKC+UQ3
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.