Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Installation Procedure
Install the rear body structure stop lamp (1).
- CAUTION:
Refer to Fastener Caution .
Install the 3 rear combination lamp nuts (1) and tighten to 4.7 N.m (42 lb in).
Install the 2 tail lamp bracket bolts (1) and tighten to 2.5 N.m (22 lb in).
- Connect the electrical connector.
- Rear Bumper Fascia - Install - Rear Bumper Fascia Replacement (Base, Uplevel) , or Rear Bumper Fascia Replacement (ZL1)
Rear Body Structure Stop Lamp Trim Panel (2) - Install - Rear Body Structure Stop Lamp Trim Panel Replacement
- Install the appropriate rear compartment side trim panel:
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.