Programming a New Control Module

2022 Chevrolet Camaro ZL1, 2D Convertible, Standard TransSECTION Programming a New Control Module

To program a new control module, perform the following procedure:

  1. Install the special tool: EL-49642 SPS Programming Support Tool
  2. Ignition - On/Vehicle - In Service Mode
  3. Access SPS and follow the on-screen instructions for the control module: K47 Rear Differential Clutch Control Module
  4. Perform the SPS function: Prepare Control Module for Removal
  5. Perform the SPS function: Programming
  6. Perform the SPS function: Setup
  7. Clear DTCs after programming is complete. Clearing powertrain DTCs will set the Inspection/Maintenance (I/M) system status indicators to No.
  8. Perform the configuration/reset function: Rear Differential Clutch Control Module Calibration
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.