Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2020TAHOE LS, 4WD, GAS/ETHANOLREPAIR AND DIAGNOSIS (SINGLE PAGE)QUICK LOOKUPSWIRING DIAGRAMSCOMPONENT CONNECTOR END VIEWS (S79P - X92A)COMPONENT CONNECTOR END VIEWSS145 CENTER CONSOLE COMPARTMENT COOLER SWITCH (Z75)
2020 Chevrolet Tahoe LS, 4WD, Gas/Ethanol
S145 Center Console Compartment Cooler Switch (Z75)
2020 Chevrolet Tahoe LS, 4WD, Gas/EthanolSECTION S145 Center Console Compartment Cooler Switch (Z75)
Connector Part Information
|
Terminal Part Information
| Terminal Type ID | Terminated Lead | Diagnostic Test Probe | Terminal Removal Tool | Service Terminal | Tray Name | Core Crimp | Insulation Crimp |
|---|---|---|---|---|---|---|---|
| I | Not Required | J-35616-64B (LT BU) | No Tool Required | Not Required | Not Required | Not Required | Not Required |
| Pin | Size | Color | Circuit | Function | Terminal Type ID | Option |
|---|---|---|---|---|---|---|
| 1 | 0.5 | YE | 6817 | LED Backlight Dimming Control 1 | I | - |
| 2 | 0.35 | BN | 6532 | Rear Compartment Lid On/Off Control | I | - |
| 3 | 0.75 | BK | 1050 | Ground 10 | I | - |
| 4 | - | - | - | Not Occupied | - | - |
| 5 | 0.35 | GY/BK | 2546 | Rear Steering Motor Control Phase B | I | - |
| 6 | 0.5 | WH | 6816 | Indicator Dimming Control | I | - |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.