SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2020TAHOE LS, 4WD, GAS/ETHANOLREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTANTI-THEFT SYSTEMSREMOTE FUNCTIONSREPAIR INSTRUCTIONSKEYLESS ENTRY CONTROL MODULE REPLACEMENT
2020 Chevrolet Tahoe LS, 4WD, Gas/Ethanol

Keyless Entry Control Module Replacement

2020 Chevrolet Tahoe LS, 4WD, Gas/EthanolSECTION Keyless Entry Control Module Replacement
GM3635725Courtesy of GENERAL MOTORS COMPANY
Callout Component Name

Preliminary Procedure

  1. Remove the left hand quarter lower rear trim door from the left quarter lower rear trim panel.
  2. Remove the body side rear trim panel stowage compartment tray from the left quarter lower rear trim panel, if vehicle is a long wheelbase.
  3. Remove the body side rear trim panel cup holder from the quarter lower rear trim panel, if the vehicle is a short wheelbase.
1 Keyless Entry Control Module

Procedure

  1. Disconnect the electrical connectors.
  2. Release module from retaining tabs on bracket.
  3. For programming and set up information, refer to Control Module References .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.