SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2020TAHOE FL, RWD, GAS/ETHANOLREPAIR AND DIAGNOSISBODY & FRAMESEATSPOWER SEATSREPAIR INSTRUCTIONSFRONT SEAT ADJUSTER MEMORY MODULE BRACKET REPLACEMENT
2020 Chevrolet Tahoe FL, RWD, Gas/Ethanol

Front Seat Adjuster Memory Module Bracket Replacement

2020 Chevrolet Tahoe FL, RWD, Gas/EthanolSECTION Front Seat Adjuster Memory Module Bracket Replacement
GM3258748Courtesy of GENERAL MOTORS COMPANY
Callout Component Name
1 Front Seat Adjuster Memory Module Bracket Replacement

Procedure

  1. Raise the seat to the highest position to gain access to the module bracket.
  2. Disconnect the electrical connection.
  3. Gently pull forward on the front of the tray to disconnect it from the electrical tray rod.
  4. Gently push up on the rear of the cover to disengage the remaining retainers from the seat adjuster actuator motor mounting bracket.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.