SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2020SPARK LS, STANDARD TRANSREPAIR AND DIAGNOSISELECTRICALBODY ELECTRICALELECTRICAL COMPONENT LOCATOR AND HARNESS ROUTING VIEWSELECTRICAL COMPONENT LOCATIONSINSTRUMENT PANEL/CENTER CONSOLE COMPONENT VIEWSSTEERING COLUMN COMPONENTS (LHD)
2020 Chevrolet Spark LS, Standard Trans

Steering Column Components (LHD)

2020 Chevrolet Spark LS, Standard TransSECTION Steering Column Components (LHD)
GM5311710Courtesy of GENERAL MOTORS COMPANY
Steering Column Components (LHD)

Component Name Callout
K43 Power Steering Control Module K43 Power Steering Control Module X1 (LHD) , K43 Power Steering Control Module X1 (Right Hand Drive) , and K43 Power Steering Control Module X2 1
S78 Turn Signal/Multifunction Switch S78 Turn Signal/Multifunction Switch (-C80) , and S78 Turn Signal/Multifunction Switch (C80) 2
X85 Steering Wheel Air Bag Coil X85 Steering Wheel Air Bag Coil X1 , X85 Steering Wheel Air Bag Coil X2 , and X85 Steering Wheel Air Bag Coil X3 3
S82 Windshield Wiper/Washer Switch S82 Windshield Wiper/Washer Switch (-C80) , and S82 Windshield Wiper/Washer Switch (C80) 4
K89 Immobilizer Control Module (-AVJ) K89 Immobilizer Control Module (-AVJ+LHD) , and K89 Immobilizer Control Module (-AVJ+Right Hand Drive) 5
S39 Ignition Switch S39 Ignition Switch (-AVJ) 6
M93 Key Capture Solenoid Actuator (MR8) M93 Key Capture Solenoid Actuator (-AVJ) 7
K89 Immobilizer Control Module (-AVJ) K89 Immobilizer Control Module (-AVJ+LHD) , and K89 Immobilizer Control Module (-AVJ+Right Hand Drive) 8
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.