Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2020SPARK LS, STANDARD TRANSREPAIR AND DIAGNOSISBRAKESTRACTION CONTROLANTILOCK BRAKE SYSTEMREPAIR INSTRUCTIONSREAR WHEEL SPEED SENSOR REPLACEMENTREMOVAL PROCEDURE
2020 Chevrolet Spark LS, Standard Trans
Removal Procedure
2020 Chevrolet Spark LS, Standard TransSECTION Removal Procedure
- Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
- Remove the tire and wheel. Refer to Tire and Wheel Removal and Installation .
Detach the rear wheel speed sensor harness from the body frame mounted bracket (1).
- Detach the rear wheel speed sensor harness from the rear axle mounted bracket (2).
Disconnect the rear wheel speed sensor electrical connector (1) from the body wiring harness.
Remove the rear wheel speed sensor bolt (1).
- Remove the rear wheel speed sensor (2) from the rear brake backing plate spacer.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.