Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2020SPARK LS, STANDARD TRANSREPAIR AND DIAGNOSISBODY & FRAMEDOOR LOCKSREMOTE FUNCTIONSDIAGNOSTIC INFORMATION AND PROCEDURESDTC B3109-B3113CIRCUIT/SYSTEM VERIFICATION
2020 Chevrolet Spark LS, Standard Trans
Circuit/System Verification
2020 Chevrolet Spark LS, Standard TransSECTION Circuit/System Verification
- Verify none of the DTCs listed below are set:
- DTC B3109
- DTC B3110
- DTC B3111
- DTC B3112
- DTC B3113
- If any of the DTCs are set
- Replace the battery in the appropriate keyless entry transmitter and operate the transmitter three consecutive times.
- Verify the DTC does not set.
- If the DTC sets, replace the keyless entry transmitter.
- Go to next step: If the DTC does not set
- All OK.
- Go to next step: If none of the DTCs are set
- All OK.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.