Emission Reduction Fluid Controller Replacement

2020 Chevrolet Express 2500 LS, 4.3L Eng VIN P, GasSECTION Emission Reduction Fluid Controller Replacement
WARNING: This page is about a different variant/trim than selected.
GM4603823Courtesy of GENERAL MOTORS COMPANY
Callout Component Name
Preliminary Procedure 
Emission Reduction Fluid Tank Replacement (Short Wheel Base) , or Emission Reduction Fluid Tank Replacement (Long Wheel Base) 
1 Emission Reduction Fluid Pump Module Wiring Harness [2x]
2 Emission Reduction Fluid Controller Bolt
CAUTION:

Refer to Fastener Caution .


Tighten 
9 N.m (80 lb in)
3 Emission Reduction Fluid Controller
Procedure 
If replacing, reprogram the module. Control Module References
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.