Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2020EXPRESS 2500 LS, 2.8L ENG VIN 1REPAIR AND DIAGNOSISBODY & FRAMEDOOR LOCKSVEHICLE ACCESS SYSTEMSPECIFICATIONSFASTENER SPECIFICATIONS
2020 Chevrolet Express 2500 LS, 2.8L Eng VIN 1
Fastener Specifications
2020 Chevrolet Express 2500 LS, 2.8L Eng VIN 1SECTION Fastener Specifications
Reusable Threaded Fastener Tightening Specifications
|
NOTE:
All fasteners listed in this table can be reused after removal. |
|
|---|---|
| Application | Specification |
| Metric (English) | |
| Door Lock Striker Bolt | 10 N.m (89 lb in) |
| Door Outside Handle Nut | 11 N.m (97 lb in) |
| Front Side Door Latch Bolt | 10 N.m (89 lb in) |
| Front Side Door Lock Striker Bolt | 10 N.m (89 lb in) |
| Intermediate Side Door Lock Nut | 10 N.m (89 lb in) |
| Intermediate Side Door Lock Screw | 10 N.m (89 lb in) |
| Rear Door Latch Bolt | 25 N.m (18 lb ft) |
| Rear Door Lock Screw | 10 N.m (89 lb in) |
| Rear Door Lower Striker Bolt | 10 N.m (89 lb in) |
| Rear Door Upper Striker Bolt | 10 N.m (89 lb in) |
| Rear Side Door Latch Bolt | 10 N.m (89 lb in) |
| Rear Side Door Latch Control Nut | 11 N.m (97 lb in) |
| Rear Side Door Lower Latch Striker Bolt | 10 N.m (89 lb in) |
| Rear Side Door Upper Latch Bolt | 25 N.m (18 lb ft) |
| Rear Side Door Upper Latch Striker Bolt | 10 N.m (89 lb in) |
| Side Rear Door Lower Door Latch Bolt | 11 N.m (97 lb in) |
| Side Rear Door Upper Latch Bolt | 25 N.m (18 lb ft) |
| Sliding Door Outside Handle Nut | 11 N.m (97 lb in) |
| Sliding Door Rear Lock Bolt | 10 N.m (89 lb in) |
| Sliding Side Door Control Bolt | 10 N.m (89 lb in) |
| Strut Ball Stud Bracket Bolt | 20 N.m (15 lb ft) |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.