Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2020EXPRESS 2500 LS, 2.8L ENG VIN 1REPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTINFOTAINMENTCELLULAR, ENTERTAINMENT, AND NAVIGATION SYSTEMREPAIR INSTRUCTIONSRADIO ANTENNA CABLE REPLACEMENTREMOVAL PROCEDURE
2020 Chevrolet Express 2500 LS, 2.8L Eng VIN 1
Removal Procedure
2020 Chevrolet Express 2500 LS, 2.8L Eng VIN 1SECTION Removal Procedure
Body Hinge Pillar Garnish Molding-Right Side (1) - Remove - Body Hinge Pillar Trim Panel Replacement
Disconnect the electrical connector.
- Reposition the front floor panel carpet as necessary.
- Release the radio antenna cable grommet. (1)
- Attach mechanics wire to the cable.
Radio Antenna (1) - Remove - Radio Antenna Replacement
Radio Antenna Bezel (1) - Remove
- Radio Antenna Base Bolt (2) - Remove [2x]
- Release the retainer. (3)
- Radio Antenna Cable (4) - Remove
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.