Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2020CAMARO SS, 2D COUPE, STANDARD TRANSREPAIR AND DIAGNOSISBODY & FRAMEEXTERIOR/INTERIOR TRIMINTERIOR TRIM AND PANELINGSPECIFICATIONSFASTENER SPECIFICATIONS
2020 Chevrolet Camaro SS, 2D Coupe, Standard Trans
Fastener Specifications
2020 Chevrolet Camaro SS, 2D Coupe, Standard TransSECTION Fastener Specifications
Single Use Non-Threaded Fasteners/Components
|
NOTE:
All fasteners/components listed in this table MUST BE DISCARDED and replaced with NEW after removal. |
|---|
| Application |
| Front Side Door Trim Belt Line Clip |
| Front Side Door Trim High - Retention Retainer |
Reusable Threaded Fastener Tightening Specifications
|
NOTE:
All fasteners listed in this table can be reused after removal. |
|
|---|---|
| Application | Specification |
| Metric (English) | |
| Accessory Switch Panel Bolt | 2.5 N.m (22 lb in) |
| Body Side Rear Window Garnish Molding Bolt | 3 N.m (27 lb in) |
| Center Pillar Upper Garnish Molding Bolt | 3 N.m (27 lb in) |
| Front Side Door Armrest Switch Mount Plate | 2.5 N.m (22 lb in) |
| Front Side Door Inside Handle Fastener | 2.5 N.m (22 lb in) |
| Front Side Door Trim Panel Applique Fastener | 2.5 N.m (22 lb in) |
| Front Side Door Trim Panel Fastener | 2.5 N.m (22 lb in) |
| Sunshade Fastener | 2.5 N.m (22 lb in) |
| Sunshade Support Fastener | 2.5 N.m (22 lb in) |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.