Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2020CAMARO SS, 2D COUPE, STANDARD TRANSREPAIR AND DIAGNOSISACCESSORIES & EQUIPMENTDRIVERS ASSISTANCE SYSTEMS - ADASDRIVER ASSISTANCE SYSTEMSDIAGNOSTIC INFORMATION AND PROCEDURESDTC B1A01CIRCUIT/SYSTEM VERIFICATION
2020 Chevrolet Camaro SS, 2D Coupe, Standard Trans
Circuit/System Verification
2020 Chevrolet Camaro SS, 2D Coupe, Standard TransSECTION Circuit/System Verification
- Ignition - On/Vehicle - In Service Mode
- Clear DTCs
- Operate the vehicle within the Conditions for Running the DTC.
- Verify DTC B1A01 is not set.
- If the DTC is set
- Program the control module: B174W Frontview Camera - Windshield
- Operate the vehicle within the Conditions for Running the DTC.
- Verify DTC B1A01 is not set.
- If the DTC is set
Replace the component: B174W Frontview Camera - Windshield
- Go to next step: If the DTC is not set
- If the DTC is set
- All OK.
- Go to next step: If the DTC is not set
- All OK.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.