SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2019TRAX PREMIER, AWDREPAIR AND DIAGNOSISSTEERINGSTEERING COLUMNSTEERING WHEEL AND COLUMNDIAGNOSTIC INFORMATION AND PROCEDURESDTC B2910CIRCUIT/SYSTEM VERIFICATION
2019 Chevrolet Trax Premier, AWD

Circuit/System Verification

2019 Chevrolet Trax Premier, AWDSECTION Circuit/System Verification
  1. Ignition - On / Vehicle - In Service Mode
  2. Clear the DTCs.
  3. Verify DTC B2910 is not set.
    • If the DTC is set 
    1. Perform the following learn procedure:Immobilizer System Component Programming - Select the Body Control Module Immobilizer (IMMO) Function with New Transponder or Remote Key, but use the customer's existing key.
    2. Clear the DTCs.
    3. Ignition/Vehicle & All vehicle systems - Off
    4. Door - All - Closed
    5. Wait for greater than 5 min.
    6. Ignition - On / Vehicle - In Service Mode
    7. Operate the vehicle within the Conditions for Running the DTC.

      Verify the DTC does not set.

      • If the DTC sets - Replace the component:K60 Steering Column Lock Module
      • Go to next step: If the DTC is not set
    8. All OK.
    • Go to next step: If the DTC is not set 
  4. All OK.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.