Power Steering Pump Pulley Replacement

2019 Chevrolet Trax Premier, AWDSECTION Power Steering Pump Pulley Replacement
GM2028041Courtesy of GENERAL MOTORS COMPANY
Callout Component Name
Preliminary Procedure 
Power Steering Pump Replacement 
1 Power Steering Pump Pulley

Procedure

  1. Use the CH-25034 - C  pulley remover to remove the power steering pump pulley.
  2. Use the CH-25033 - C  pulley installer to install the power steering pump pulley.

Special Tools

  • CH-25033 - C  Pulley Installer
  • CH-25034 - C  Pulley Remover

Equivalent regional tools:Special Tools 
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.