Rear Side Door Latch Replacement

2019 Chevrolet Trax Premier, AWDSECTION Rear Side Door Latch Replacement
WARNING: This page is about a different car, the 2018 Chevrolet Trax and 2018 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.
GM2770787
Callout Component Name
Preliminary Procedure 
Remove the rear side door window rear guide. Refer to Rear Side Door Window Rear Guide Replacement .
1 Rear Side Door Latch Screw (Qty: 3)
CAUTION:

Refer to Fastener Caution .

Procedures

  1. Release the rear inside door handle cable from the retainers.
  2. Release the rear outside door handle rod clip so that the handle rod can be free from the door latch assembly
  3. Disconnect the rear side door latch electrical connector.

Tighten 
10 N.m (89 lb in)
2 Rear Side Door Latch Assembly

Procedure

  1. Transfer the rear side door lock rods.
  2. Rear outside door handle rod adjustment. Refer to Rear Side Door Outside Handle Rod Adjustment .
NOTE:

Inspect the door lock system for proper operation before installing the door trim.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.