SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2019TRAX PREMIER, AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 99 (POWER DOOR LOCK SYSTEM AND RELEASE SYSTEMS)REPAIR INSTRUCTIONSFRONT SIDE DOOR OUTSIDE HANDLE REPLACEMENT (WITH ATH)
2019 Chevrolet Trax Premier, AWD

Front Side Door Outside Handle Replacement (With ATH)

2019 Chevrolet Trax Premier, AWDSECTION Front Side Door Outside Handle Replacement (With ATH)
WARNING: This page is about a different car, the 2018 Chevrolet Trax and 2018 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.
GM4256157
Callout Component Name

Preliminary Procedures

  1. Front Side Door Lock Cylinder Bezel Replacement 
  2. Front Side Door Trim Replacement (Buick)Front Side Door Trim Replacement (Chevrolet)
  3. Front Side Door Water Deflector - Remove
  4. Disconnect the electrical connector.
1 Front Side Door Outside Handle
  1. Pull the front side door outside handle molding outward and hold it in the open position.
  2. Slide the front side door outside handle molding rearward and then outwards in a swinging motion releasing the handle from the front side door outside handle bracket.
  3. Install the front side door outside handle molding into the handle bracket.
  4. While screwing in the screw for the lock cylinder opening cover, hold the handle in the open position, this will avoid the door handle from snapping once the spring pressure is relieved and the door handle returns to the close position.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.