Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Circuit/System Verification
- Ignition - On / Vehicle - In Service Mode
- Verify the scan tool parameter: Trunk Lid/Liftgate Window Exterior Unlatch Switch = Inactive
- If not the specified state
Refer to: Circuit/System Testing - Test 1
- Go to next step: If the specified state
- If not the specified state
- Operate the component:S46B Liftgate Unlatch Switch - Pressed
Verify the scan tool parameter: Trunk Lid/Liftgate Window Exterior Unlatch Switch = Active
- If not the specified state
Refer to: Circuit/System Testing - Test 1
- Go to next step: If the specified state
- If not the specified state
- Perform the scan tool control function: Liftgate Unlatch - Unlatch
Verify the component produces a clicking sound: M30 Liftgate Latch
- If the component does not produce a sound
Refer to: Circuit/System Testing - Test 2
- Go to next step: If the component produces a sound
- If the component does not produce a sound
- All OK.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.