Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2019TRAX PREMIER, AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 96 (SUNROOF SYSTEM)DIAGNOSTIC INFORMATION AND PROCEDURESDTC B369CCIRCUIT/SYSTEM TESTING
2019 Chevrolet Trax Premier, AWD
Circuit/System Testing
2019 Chevrolet Trax Premier, AWDSECTION Circuit/System Testing
WARNING: This page is about a different car, the 2018 Chevrolet Trax and 2018 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.
- Ignition OFF and all vehicle systems OFF, disconnect the harness connector at the S88 Sunroof Tilt Switch. It may take up to 2 min for all vehicle systems to power down.
- Test for less than 10 Ω between the low reference circuit terminal 1 and ground.
- If 10 Ω or greater
- Ignition OFF, disconnect the harness connector at the K61 Sunroof Control Module.
- Test for less than 2 Ω in the low reference circuit end to end.
- If 2 Ω or greater, repair the open/high resistance in the circuit.
- If less than 2 Ω, test or replace the K61 Sunroof Control Module.
- Go to next step: If less than 10 Ω
- Ignition ON.
- Verify the scan tool Sunroof Tilt Switch parameter is Short to Battery.
- If not Short to Battery
- Ignition OFF, disconnect the harness connector at the K61 Sunroof Control Module.
- Test for infinite resistance between the signal circuit terminal 4 and ground.
- If less than infinite resistance, repair the short to ground on the circuit.
- If infinite resistance, replace the K61 Sunroof Control Module.
- Go to next step: If Short to Battery
- Install a 5 A fused jumper wire between the signal circuit terminal 4 and the low reference circuit terminal 1.
- Verify the scan tool Sunroof Tilt Switch parameter is Short to Ground.
- If not Short to Ground
- Ignition OFF, disconnect the harness connector at the K61 Sunroof Control Module.
- Test for less than 1 V between the signal circuit terminal 4 and ground.
- If 1 V or greater, repair the short to voltage on the circuit.
- Go to next step: If less than 1 V
- Test for less than 2 Ω in the signal circuit end to end.
- If 2 Ω or greater, repair the open/high resistance in the circuit.
- If less than 2 Ω, replace the K61 Sunroof Control Module.
- Go to next step: If Short to Ground
- All OK.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.