Driver or Passenger Seat Adjuster Memory Module Replacement (Buick)

2019 Chevrolet Trax Premier, AWDSECTION Driver or Passenger Seat Adjuster Memory Module Replacement (Buick)
WARNING: This page is about a different car, the 2018 Chevrolet Trax and 2018 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.
GM2869190
Callout Component Name
Preliminary ProcedureΒ 
Remove the front seat. Refer to Driver or Passenger Seat Removal and Installation .
1 Driver or Passenger Seat Adjuster Memory Module Fastener (Qty: 4)
CAUTION:

Refer to Fastener Caution .

2 Driver or Passenger Seat Adjuster Memory Module

Procedure

  1. Disconnect the electrical connectors.
  2. Remove the module from the adjuster memory and wiring harness bracket.
  3. Refer to Control Module References for programing and setup information.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.