Circuit/System Verification

2019 Chevrolet Trax Premier, AWDSECTION Circuit/System Verification
WARNING: This page is about a different car, the 2018 Chevrolet Trax and 2018 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition/Vehicle - Off
  2. Ignition - On / Vehicle - In Service Mode
  3. Verify the component turns On and Off:
    • Side Blind Zone Alert Indicator@A9A Outside Rearview Mirror - Driver
    • Side Blind Zone Alert Indicator@A9B Outside Rearview Mirror - Passenger
    • Go to next step: If the component turns On and Off 
  4. Verify that no DTCs are set.
    • Go to next step: If no DTC is set 
  5. Verify the following control modules contain the latest software: B218L Side Object Sensor Module - Left
    • If not the latest software is contained 

      Program the control module: B218L Side Object Sensor Module - Left

    • Go to next step: If the latest software is contained 
  6. All OK.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.