Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2019TRAX PREMIER, AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 92 (DRIVER ASSISTANCE SYSTEMS)DIAGNOSTIC INFORMATION AND PROCEDURESDTC P15F6CIRCUIT/SYSTEM VERIFICATION
2019 Chevrolet Trax Premier, AWD
Circuit/System Verification
2019 Chevrolet Trax Premier, AWDSECTION Circuit/System Verification
WARNING: This page is about a different car, the 2018 Chevrolet Trax and 2018 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
- DTC P15F6 is an informational DTC.
- Diagnose all other K20 Engine Control Module DTCs prior to DTC P15F6.
- Ignition - On / Vehicle - In Service Mode
- Verify no other DTCs are set.
- If any other DTCs are set
Diagnose other DTCs first.Refer to: Diagnostic Trouble Code (DTC) List - Vehicle .
- Go to next step: If no other DTCs are set
- If any other DTCs are set
- Complete the diagnosis by looking for an intermittent serial data circuit fault. Refer to Scan Tool Does Not Communicate with High Speed GMLAN Device
.
- If an intermittent serial data circuit fault is found
Repair as necessary.
- Go to next step: If an intermittent serial circuit fault is not found
- If an intermittent serial data circuit fault is found
- Clear DTCs and operate the vehicle in the conditions that the customer experienced.
- Verify DTC P15F6 is not set.
- If the DTC sets
Replace the component: K109 Frontview Camera Module
- Go to next step: If the DTC does not set
- If the DTC sets
- All OK.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.