Installation Procedure

2019 Chevrolet Trax Premier, AWDSECTION Installation Procedure
WARNING: This page is about a different car, the 2018 Chevrolet Trax and 2018 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.
  1. GM4491207

    Front Floor Console (1) - Install

  2. Connect the electrical connectors.
  3. GM4491531
    CAUTION:

    Refer to Fastener Caution .

    Front Floor Console Bolt (1) - Install and tighten [4x] 2.5 N.m (22 lb in)

  4. GM2777221

    Front Floor Console Extension Panel - Right Side (1) - Install - Front Floor Console Extension Replacement - Right SideΒ 

  5. GM2852002

    Front Floor Console Extension Panel - Left Side (2) - Install - Front Floor Console Extension Replacement - Left SideΒ 

  6. GM4491204

    Front Floor Console Stowage Tray (2) - Install - Front Floor Console Stowage Tray Replacement (Chevrolet)Β 

  7. GM4491195

    Front Floor Lower Console (2) - Install - Front Floor Lower Console Replacement (Chevrolet)Β 

  8. GM4491184

    Front Floor Console Applique (1) - Install

  9. GM4491203

    Automatic Transmission Control Indicator Bezel (1) - Install

  10. GM4491170

    Instrument Panel Switch Trim Plate (1) - Install - Instrument Panel Switch Trim Plate Replacement (Chevrolet)Β 

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.