Theft Deterrent Module Replacement (Chevrolet, Without BTM)

2019 Chevrolet Trax Premier, AWDSECTION Theft Deterrent Module Replacement (Chevrolet, Without BTM)
WARNING: This page is about a different car, the 2018 Chevrolet Trax and 2018 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.
GM4473413
Callout Component Name

Preliminary Procedures

  1. Reposition the steering column upper trim cover as necessary. Steering Column Upper Trim Cover Replacement (Chevrolet, With BTM)Steering Column Upper Trim Cover Replacement (Chevrolet, Without BTM)Steering Column Upper Trim Cover Replacement (Buick, With BTM)
  2. Ignition Lock Cylinder Opening Trim Cover Replacement (Chevrolet, Without BTM)
  3. Steering Column Lower Trim Cover Replacement (Buick, With BTM)Steering Column Lower Trim Cover Replacement (Chevrolet, With BTM)Steering Column Lower Trim Cover Replacement (Chevrolet, Without BTM)
1 Theft Deterrent Module Bolt[2x]
CAUTION:

Refer to Fastener Caution .


TightenΒ 
2.5 N.m (22 lb in)
2 Theft Deterrent Module

Procedure

  1. Disconnect the electrical connector.
  2. Release the retaining tabs and remove the theft deterrent module from the ignition and start switch housing.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.