Circuit/System Verification

2019 Chevrolet Trax Premier, AWDSECTION Circuit/System Verification
WARNING: This page is about a different car, the 2018 Chevrolet Trax and 2018 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.
  1. Perform the Programming and Setup procedure for the control module that set DTC B3902.
    NOTE:

    When performing the following step, Immobilizer System Component Programming, the module may also need to be reset by using the SPS function Prepare For Removal.

  2. Perform the Immobilizer System Component Programming Immobilizer System Component Programming .
  3. Verify DTC B3902 does not set after programming.
    • If the DTC sets after programming 

      Replace the control module that set the DTC.

    • Go to next step: If the DTC does not set after programming 
  4. All OK.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.