Power Steering Pump Pulley Replacement

2019 Chevrolet Trax Premier, AWDSECTION Power Steering Pump Pulley Replacement
WARNING: This page is about a different car, the 2018 Chevrolet Trax and 2018 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.
GM2028041
Callout Component Name
Preliminary Procedure 
Power Steering Pump Replacement 
1 Power Steering Pump Pulley

Procedure

  1. Use the CH-25034 - C  pulley remover to remove the power steering pump pulley.
  2. Use the CH-25033 - C  pulley installer to install the power steering pump pulley.

Special Tools

  • CH-25033 - C  Pulley Installer
  • CH-25034 - C  Pulley Remover

Equivalent regional tools:Special Tools 
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.