Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Removal Procedure
- Remove as much power steering fluid from the power steering fluid reservoir as possible.
Power Steering Fluid Reservoir Inlet Pipe Clamp (1) - Disengage
- Power Steering Fluid Reservoir Inlet Pipe (2)@Power Steering Fluid Reservoir - Remove
Release the power steering fluid reservoir inlet hose (1) from the plastic clip (2) and remove the plastic push pin retainer (3).
Power Steering Fluid Reservoir Inlet Pipe Clamp (1) - Disengage
- Power Steering Fluid Reservoir Inlet Pipe (2)@Power Steering Fluid Cooler - Remove
- Remove the power steering fluid reservoir inlet pipe (2) from the vehicle.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.