Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2019TRAX PREMIER, AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 6 (ENGINE COOLING SYSTEM)REPAIR INSTRUCTIONSWATER PUMP PULLEY REPLACEMENT (2H0)REMOVAL PROCEDURE
2019 Chevrolet Trax Premier, AWD
Removal Procedure
2019 Chevrolet Trax Premier, AWDSECTION Removal Procedure
WARNING: This page is about a different car, the 2018 Chevrolet Trax and 2018 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.
- Disconnect the battery negative cable. Battery Negative Cable Disconnection and Connection (without KL9)Battery Negative Cable Disconnection and Connection (with KL9)
- Engine Mount - Remove - Engine Mount Replacement
- Raise the vehicle. Lifting and Jacking the Vehicle
Rear Transmission Mount Through Bolt(1) - Remove and DISCARD
- Lower the vehicle. Lifting and Jacking the Vehicle
- Using the engine support fixture, carefully lower the engine to gain access to the water pump pulley.
- Raise the vehicle. Lifting and Jacking the Vehicle
- Drive Belt Tensioner - Remove - Drive Belt Tensioner Replacement
Water Pump Pulley Bolt(1) - Remove[3x]
- Water Pump Pulley(2) - Remove
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.