Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Filling Procedure
- Raise and support the vehicle. Lifting and Jacking the Vehicle
- CAUTION:
Refer to Fastener Caution .
Tighten the radiator drain cock (1) to 2 N.m (18 lb in).
- Install the underbody front air deflector. Underbody Front Air Deflector Replacement
- Lower the vehicle.
- NOTE:
Use a 50/50 mixture of DEX-COOL antifreeze and clean drinkable water.
The procedure below must be followed. Improper coolant level could result in a low or high coolant level condition, causing engine damage.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.