Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2019TRAX PREMIER, AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 59 (CELLULAR SYSTEM, ENTERTAINMENT SYSTEM, AND NAVIGATION SYSTEM - DIAGNOSTIC INFORMATION AND PROCEDURES)DIAGNOSTIC INFORMATION AND PROCEDURESRADIO INFORMATION DISPLAY MALFUNCTION (IO5/IO6 WITH MAH/MBC)CIRCUIT/SYSTEM VERIFICATION
2019 Chevrolet Trax Premier, AWD
Circuit/System Verification
2019 Chevrolet Trax Premier, AWDSECTION Circuit/System Verification
WARNING: This page is about a different car, the 2018 Chevrolet Trax and 2018 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.
- Vehicle OFF/Ignition OFF.
- Verify the LVDS interface cable is properly connected at the P17 Info Display Module, K188 Human Machine Interface Control Module Bypass Module, and the K74 Human Machine Interface Control Module and there is no damage to the cable or connections.
- Ignition ON/Vehicle in Service Mode, infotainment system ON.
- Verify the P17 Info Display Module does display an infotainment image.
- If the P17 Info Display Module does not display an infotainment image.
Refer to Rear Vision Camera System Malfunction (Buick)Rear Vision Camera System Malfunction (Chevrolet)
- Go to next step: If the P17 Info Display Module displays an infotainment image.
Go to next step: All OK.
- If the P17 Info Display Module does not display an infotainment image.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.