Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2019TRAX PREMIER, AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 59 (CELLULAR SYSTEM, ENTERTAINMENT SYSTEM, AND NAVIGATION SYSTEM - DIAGNOSTIC INFORMATION AND PROCEDURES)DIAGNOSTIC INFORMATION AND PROCEDURESDTC B2470CIRCUIT/SYSTEM TESTING
2019 Chevrolet Trax Premier, AWD
Circuit/System Testing
2019 Chevrolet Trax Premier, AWDSECTION Circuit/System Testing
WARNING: This page is about a different car, the 2018 Chevrolet Trax and 2018 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
- The vehicle may be equipped with sectioned coax. Test each section and replace only the faulty section, not the entire length of coax.
- The following verification requires the vehicle to be outside with an unobstructed view of the southern sky. Allow 5 min after turning the ignition ON for the GPS satellites to acquire vehicle signal.
- Ignition OFF/Vehicle OFF and all vehicle systems OFF, disconnect the violet primary cellular coax cable connector at the K73 Telematics Communication Interface Control Module. It may take up to 2 min for all vehicle systems to power down.
- Using the EL-49903-1 Test Antenna Navn-Cell Comn connect the violet coax cable to the K73 Telematics Communication Interface Control Module. Place the test antenna on the roof of the vehicle, ignition ON/vehicle in Service Mode.
- Verify the DTC does not set or a call can be completed to the OnStar Call Center while operating the vehicle within the conditions for running the DTC.
- If the DTC sets or a call can not be completed to the OnStar Call Center
Replace the K73 Telematics Communications Interface Control Module.
- Go to next step: If the DTC does not set or a call can be completed to the OnStar Call Center
- If the DTC sets or a call can not be completed to the OnStar Call Center
- Ignition OFF/Vehicle OFF.
- Disconnect the EL-49903-1 Test Antenna Navn-Cell Comn from the K73 Telematics Communication Interface Control Module
- Test the coax cable. Refer to Component Testing.
- If the coax cable does not pass the test
Replace the coax cable.
- Go to next step: If the coax cable passes the test
- If the coax cable does not pass the test
- Test or replace the T2RR Antenna - Roof Rear.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.