Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2019TRAX PREMIER, AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 59 (CELLULAR SYSTEM, ENTERTAINMENT SYSTEM, AND NAVIGATION SYSTEM - DIAGNOSTIC INFORMATION AND PROCEDURES)DIAGNOSTIC INFORMATION AND PROCEDURESDTC B125ACIRCUIT/SYSTEM VERIFICATION
2019 Chevrolet Trax Premier, AWD
Circuit/System Verification
2019 Chevrolet Trax Premier, AWDSECTION Circuit/System Verification
WARNING: This page is about a different car, the 2018 Chevrolet Trax and 2018 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.
- Inspect the antenna for proper mounting or physical damage.
- If damage is found
Repair or replace as necessary
- Go to next step: If no damage is found
- If damage is found
- Ignition ON/Vehicle in Service Mode, A11 Radio ON.
- Verify station reception is normal when tuned to several known good AM and FM stations.
- If AM or FM reception is poor.
Refer to Circuit/System Testing
- Go to next step: If reception is normal
- If AM or FM reception is poor.
- All OK.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.