Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2019TRAX PREMIER, AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 59 (CELLULAR SYSTEM, ENTERTAINMENT SYSTEM, AND NAVIGATION SYSTEM - DIAGNOSTIC INFORMATION AND PROCEDURES)DIAGNOSTIC INFORMATION AND PROCEDURESAUXILIARY AUDIO INPUT MALFUNCTION (IO5/IO6)CIRCUIT/SYSTEM VERIFICATION
2019 Chevrolet Trax Premier, AWD
Circuit/System Verification
2019 Chevrolet Trax Premier, AWDSECTION Circuit/System Verification
WARNING: This page is about a different car, the 2018 Chevrolet Trax and 2018 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.
- Verify DTC B124B is not set. Since occurrences of this DTC can be caused by an incompatible or faulty USB device, review with the customer the conditions under which their concern occurred.
- If DTC B124B is set.
Refer to Circuit/System Testing.
- Go to next step: If DTC B124B is not set.
- If DTC B124B is set.
- Ignition On/Vehicle in Service Mode. Infotainment system ON.
- Connect the EL-50334-20 Multi-Media Interface Tester (MIT) to the X83 Auxiliary Audio Input USB port and select the USB test mode.
- Verify the audio from the EL-50334-20 Multi-Media Interface Tester (MIT) is heard through the infotainment system while operating the system to play audio from the test tool.
- If audio is not heard from the test tool
Refer to Circuit/System Testing
- Go to next step: If audio is heard from test tool
- If audio is not heard from the test tool
- Verify the infotainment system can be switched to AUX as the audio source with the EL-50334 - 20 Multi-Media Interface Tester (MIT) connected to the auxiliary audio input jack.
- If the infotainment system can not be switched to AUX as the audio source
Refer to Circuit/System Testing
- Go to next step: If the infotainment system can be switched to AUX as the audio source
- If the infotainment system can not be switched to AUX as the audio source
- Verify the audio from the EL-50334 - 20 Multi-Meida Interface Tester (MIT) is heard through the vehicle infotainment system while operating the test tool to begin audio playback.
- If audio is not heard from the test tool.
Refer to Circuit/System Testing
- Go to next step: If audio is heard from the test tool.
- If audio is not heard from the test tool.
- All OK
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.