Windshield Washer Pump Hose Replacement (Chevrolet)

2019 Chevrolet Trax Premier, AWDSECTION Windshield Washer Pump Hose Replacement (Chevrolet)
WARNING: This page is about a different car, the 2018 Chevrolet Trax and 2018 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.
GM2845517
Callout Component Name

Preliminary Procedures

  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the front wheelhouse liner. Refer to Front Wheelhouse Liner Replacement (Chevrolet)Front Wheelhouse Liner Replacement (Buick) .
1 Windshield Washer Pump Hose

Procedure

  1. Place a collecting container under the windshield washer solvent container.
  2. Disconnect the windshield washer pump hose from the windshield washer pump.
  3. Lower the vehicle.
  4. Disconnect the windshield washer pump hose from the connection piece at the air inlet grille panel.
  5. Remove the windshield washer pump hose from the two clips on the windshield washer solvent container.
NOTE:

Observe the routing of the windshield washer pump hose for installation purposes.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.