Rear Window Wiper Motor Replacement

2019 Chevrolet Trax Premier, AWDSECTION Rear Window Wiper Motor Replacement
WARNING: This page is about a different car, the 2018 Chevrolet Trax and 2018 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.
GM2844480
Callout Component Name

Preliminary Procedure

  1. Open and support the liftgate assembly.
  2. Remove the rear window wiper arm assembly. Refer to Rear Window Wiper Arm ReplacementΒ .
  3. Remove the rear liftgate lower trim finish panel. Refer to Liftgate Lower Trim Finish Panel Replacement .
  4. Disconnect the rear window wiper motor electrical connector.
1 Rear Window Wiper Motor Bolt (Qty: 3)
CAUTION:

Refer to Fastener Caution .


TightenΒ 
9 N.m (80 lb in)
2 Rear Window Wiper Motor

Procedure

  1. Pull the rear window wiper motor inward from the rear liftgate.
  2. Inspect the rear window wiper motor window grommet for damage. Replace if needed.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.