Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2019TRAX PREMIER, AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 56 (WIPER SYSTEM AND WASHER SYSTEM)DIAGNOSTIC INFORMATION AND PROCEDURESWASHER MALFUNCTIONCOMPONENT TESTING
2019 Chevrolet Trax Premier, AWD
Component Testing
2019 Chevrolet Trax Premier, AWDSECTION Component Testing
WARNING: This page is about a different car, the 2018 Chevrolet Trax and 2018 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.
Washer Switch
- Ignition OFF, disconnect the harness connector at the S82 Windshield Wiper/Washer Switch.
- Test for infinite resistance between the signal terminal 5 and the low reference terminal 2 with the switch in the open position.
- If less than infinite resistance
Replace the S82 Windshield Wiper/Washer Switch.
- Go to next step: If infinite resistance
- If less than infinite resistance
- Test for less than 2 Ω between the signal circuit terminal 5 and the low reference circuit terminal 2 with the switch in the closed position.
- If 2 Ω or greater
Replace the S82 Windshield Wiper/Washer Switch.
- Go to next step: If less than 2 Ω
- If 2 Ω or greater
- All OK
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.