Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Load Floor Front Trim Panel Support Replacement (Buick)
2019 Chevrolet Trax Premier, AWDSECTION Load Floor Front Trim Panel Support Replacement (Buick)
WARNING: This page is about a different car, the 2018 Chevrolet Trax and 2018 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.
| Callout | Component Name |
|---|---|
| Preliminary Procedure Remove the load floor stowage compartment cover. Refer to Load Floor Stowage Compartment Cover Replacement (Buick) . |
|
| 1 | Rear Compartment Floor Stowage Compartment Divider Retainer |
| 2 | Load Floor Front Trim Panel Support
NOTE:
Load floor front trim panel support on left side must be removed prior to removal of right side load floor front trim panel support, due to overlap. |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.