SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2019TRAX PREMIER, AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 54 (EXTERIOR TRIM)REPAIR INSTRUCTIONSBODY SIDE UPPER FRONT APPLIQUE REPLACEMENT
2019 Chevrolet Trax Premier, AWD

Body Side Upper Front Applique Replacement

2019 Chevrolet Trax Premier, AWDSECTION Body Side Upper Front Applique Replacement
WARNING: This page is about a different car, the 2018 Chevrolet Trax and 2018 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.
GM2844829
Callout Component Name
CAUTION:

Refer to Exterior Trim Emblem Removal Caution .

Preliminary Procedure Open the front door.
1 Body Side Upper Front Applique

Procedure

  1. Using a trim type release tool, disengage the rear lower clip from the body side outer panel.
  2. Gently pull the body side upper front applique away from the vehicle to disengage the two remaining clips.
  3. Upon installation, using the palm of the hand secure each retainer location until fully seated to the body side outer panel and front fender.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.