Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2019TRAX PREMIER, AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 5 (WIRING SYSTEMS AND POWER MANAGEMENT - DIAGNOSTIC INFORMATION AND PROCEDURES)DIAGNOSTIC INFORMATION AND PROCEDURESIGNITION MODE SWITCH INDICATOR MALFUNCTIONCIRCUIT/SYSTEM VERIFICATION
2019 Chevrolet Trax Premier, AWD
Circuit/System Verification
2019 Chevrolet Trax Premier, AWDSECTION Circuit/System Verification
WARNING: This page is about a different car, the 2018 Chevrolet Trax and 2018 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.
- Ignition ON.
- Verify the green LED turns ON and OFF when commanding the Run/Start Power Mode Indicator On and Off with the scan tool.
- If the green LED does not turn ON and OFF
Refer to Circuit/System Testing - Green LED Test.
- Go to next step: If the green LED turns ON and OFF
- If the green LED does not turn ON and OFF
- Verify the amber LED turns ON and OFF when commanding the Accessory Power Mode Indicator On and Off with the scan tool.
- If the amber LED does not turn ON and OFF
Refer to Circuit/System Testing - Amber LED Test.
- Go to next step: If the amber LED turns ON and OFF
- If the amber LED does not turn ON and OFF
- All OK.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.