Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Removal Procedure
Floor Air Outlet Duct(2) - Remove - Floor Front Air Outlet Duct Replacement - Left Side (Chevrolet)Floor Front Air Outlet Duct Replacement - Left Side (Buick)
Instrument Panel Knee Bolster(2) - Remove - Instrument Panel Knee Bolster Replacement (Buick)Instrument Panel Knee Bolster Replacement (Chevrolet)
Heater and Air Conditioning Control with Cable Control(2) - Remove - Heater and Air Conditioning Control with Cable Control Replacement (C60)
Remove the mode control cable retaining screw (1) and the mode control cable (2) from the heater and air conditioning evaporator and blower module.
- NOTE:
When replacing the mode control cable, perform step 5, 6, and 7 in order to remove the mode control cable without the removal of the instrument panel tie bar.
Remove the mode control cable pulley (3) from heater and air conditioning evaporator and blower module control side cable end, and release the cable retainer (1).
- Remove the wire (2) from the mode control cable pulley groove (3).
Move the mode control cable barrel (3) forward out of the pulley (2) detent, and slip the cable out of the detent to remove the mode control cable assembly (1) from the pulley (2).
Maneuver the mode control cable (1) out from behind the tie bar and the instrument panel.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.