Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2019TRAX PREMIER, AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 26 (ELECTRICAL COMPONENT LOCATOR)COMPONENT LOCATORFRONT OF VEHICLE/ENGINE COMPARTMENT COMPONENT VIEWS (TRAX)LEFT OF ENGINE COMPARTMENT COMPONENTS (TRAX)
2019 Chevrolet Trax Premier, AWD
Left of Engine Compartment Components (Trax)
2019 Chevrolet Trax Premier, AWDSECTION Left of Engine Compartment Components (Trax)
WARNING: This page is about a different car, the 2018 Chevrolet Trax and 2018 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.
| Items |
|---|
| 1 B19B Brake Booster Vacuum Sensor B19B Brake Booster Vacuum Sensor |
| 2 M75 Windshield Wiper Motor M75 Windshield Wiper Motor |
| 3 K17 Electronic Brake Control Module (JL4) |
| 4 X50D Fuse Block - Battery X50D Fuse Block - Battery X1X50D Fuse Block - Battery X2X50D Fuse Block - Battery X3X50D Fuse Block - Battery X4X50D Fuse Block - Battery X5 |
| 5 X50A Fuse Block - Underhood X50A FUSE BLOCK - UNDERHOOD X1X50A Fuse Block - Underhood X2X50A Fuse Block - Underhood X3X50A Fuse Block - Underhood X4X50A Fuse Block - Underhood, Wire Entry (Trax) |
| 6 B18 Battery Current Sensor B18 Battery Current Sensor |
| 7 B20 Brake Fluid Level Switch B20 Brake Fluid Level Switch |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.