Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2019TRAX PREMIER, AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 25 (PROGRAMMING AND SETUP - ALL SYSTEMS)REPAIR INSTRUCTIONSA11 RADIO: PROGRAMMING AND SETUP (IOA)DIAGNOSTIC AIDS
2019 Chevrolet Trax Premier, AWD
Diagnostic Aids
2019 Chevrolet Trax Premier, AWDSECTION Diagnostic Aids
WARNING: This page is about a different car, the 2018 Chevrolet Trax and 2018 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.
- If programming of the control module is being performed at the direction of a bulletin or PI, follow the instructions provided in that document.
- During audio system programming you may be required to select multiple calibrations dependent upon vehicle equipment. Have the vehicle build/RPO information available during the following procedure to ensure the correct calibrations are selected.
- Dependant upon vehicle equipment, the current software level of the module, or the release of updates, USB programming may not be required when replacing/reprogramming the control module. If USB files for the application are not available via SPS, or if the files already in the radio are the same or newer than what is available via SPS, or have not been received in another manner of distribution, the USB update process will not need to be performed.
- All data will be erased from the USB device BEFORE the calibration is downloaded onto the device. To ensure important information is NOT erased, always verify that NO information is stored on the device BEFORE beginning the calibration download. If required, transfer important files to another storage device BEFORE beginning the calibration download.
- The length of time for the USB programming to complete will vary depending on the number and size of the files in the update.
- The USB programming will not allow the installation of the same software. If the same software is detected on the USB stick, Radio will display "Invalid Update" message.
- Make sure USB stick is removed after update is complete. If the USB stick is left connected an "Invalid Update" message will be displayed when the radio is powered on.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.