Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2019TRAX PREMIER, AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 18 (AUTOMATIC TRANSMISSION COOLING SYSTEM)SPECIFICATIONSFASTENER SPECIFICATIONS
2019 Chevrolet Trax Premier, AWD
Fastener Specifications
2019 Chevrolet Trax Premier, AWDSECTION Fastener Specifications
WARNING: This page is about a different car, the 2018 Chevrolet Trax and 2018 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.
Single Use Non-Threaded Fasteners/Components
|
NOTE:
All fasteners/components listed in this table MUST BE DISCARDED and replaced with NEW after removal. |
|---|
| Application |
| Transmission Fluid Cooler Pipe Fitting Retainer |
| Transmission Fluid Cooler Pipe Fitting Seal |
Reusable Threaded Fastener Tightening Specifications
|
NOTE:
All fasteners listed in this table can be reused after removal. |
|
|---|---|
| Application | Specification |
| Metric (English) | |
| Transmission Fluid Auxiliary Cooler Fastener@Transmission Fluid Cooler Thermal Bypass Valve | 8 N.m (6 lb ft) |
| Transmission Fluid Auxiliary Cooler Fastener | 6 N.m (4 lb ft) |
| Transmission Fluid Cooler Pipe Connector@Radiator | 20 N.m (15 lb ft) |
| Transmission Fluid Cooler Pipe Nut | 22 N.m (16 lb ft) |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.