Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Installation Procedure
Install a NEW fuel sender O-ring gasket (2) to the fuel sender (1).
Lower the fuel sender (1) into the fuel tank while connecting the fuel tank fuel pump module fuel pickup (2) to the fuel sender (1).
Install the fuel sender lock ring (1) to the fuel tank (2).
- Install the EN-48482 Fuel Sender Lock Ring Wrench to the fuel sender lock ring (1).
- Using the EN-48482 Fuel Sender Lock Ring Wrench and a long breaker-bar, rotate the fuel sender lock ring (1) in a clockwise direction in order to lock the lock ring.
- Connect the fuel tank sender wiring harness electrical connector.
- Install the fuel tank.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.