SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2019TRAX PREMIER, AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 15 (ENGINE CONTROLS AND FUEL - 1.4L (LUV) - REPAIR INSTRUCTIONS)REPAIR INSTRUCTIONSCRANKSHAFT POSITION SENSOR REPLACEMENT
2019 Chevrolet Trax Premier, AWD

Crankshaft Position Sensor Replacement

2019 Chevrolet Trax Premier, AWDSECTION Crankshaft Position Sensor Replacement
WARNING: This page is about a different car, the 2018 Chevrolet Trax and 2018 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.
GM2509003
Callout Component Name

Preliminary Procedures

  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the splash shield cover.
  3. Remove the transfer case, if equipped. Refer to Transfer Case Replacement .
1 Crankshaft Position Sensor Fastener
CAUTION:

Refer to Fastener Caution .


Tighten 
8 N.m (71 lb in)
2 Crankshaft Position Sensor

Procedure

  1. Disconnect the electrical wiring harness connector from the crankshaft position sensor.
  2. After replacement of the crankshaft position sensor, use a scan tool to speed up the learn process. Refer to Crankshaft Position Variation Learn .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.