SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2019TRAX PREMIER, AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 14 (ENGINE CONTROLS AND FUEL - 1.4L (LE2) - REPAIR INSTRUCTIONS)REPAIR INSTRUCTIONSFUEL TANK REPLACEMENT (AWD)INSTALLATION PROCEDURE
2019 Chevrolet Trax Premier, AWD

Installation Procedure

2019 Chevrolet Trax Premier, AWDSECTION Installation Procedure
WARNING: This page is about a different car, the 2018 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.
  1. Transfer the evaporative emission canister. Evaporative Emission Canister Replacement (AWD)Evaporative Emission Canister Replacement (FWD)
  2. Transfer the fuel sender assembly. Fuel Sender Assembly Replacement (AWD) 
  3. Transfer the fuel tank fuel pump module.
  4. Install the fuel tank to the hydraulic lift.
  5. GM2783760

    With the aid of an assistant, position the fuel tank to the vehicle.

    6. CAUTION:

    Refer to Fastener Caution .

  6. Install both fuel tank straps to the fuel tank (2) and tighten the fasteners to 22 N.m (16 lb ft).
  7. Remove the hydraulic lift from the fuel tank.
  8. Connect the EVAP system hoses. Plastic Collar Quick Connect Fitting Service 
  9. Connect the fuel feed pipe. Plastic Collar Quick Connect Fitting Service 
  10. Connect the fuel tank filler pipe. Fuel Tank Filler Pipe Replacement 
  11. GM2781400

    Connect the fuel tank fuel pump module wiring harness (1) and clip the fuel tank module wiring harness to the chassis.

  12. Install the propeller shaft. Two-Piece Propeller Shaft Replacement
  13. Install the exhaust. Exhaust Muffler Replacement (2H0)Exhaust Muffler Replacement (LUV)Exhaust Muffler Replacement (LE2)
  14. Install the right rear wheelhouse panel liner. Rear Wheelhouse Liner Replacement
  15. Lower the vehicle.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.