Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Installation Procedure
2019 Chevrolet Trax Premier, AWDSECTION Installation Procedure
WARNING: This page is about a different car, the 2018 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.
Install the fuel tank filler pipe (4) to the vehicle.
- Install the fuel tank filler pipe fastener (3) and tighten to 9 N.m (80 lb in).
- Connect the fuel tank filler pipe quick connect fitting (1). Refer to Plastic Collar Quick Connect Fitting Service .
- Install the fuel tank filler pipe clamp (2).
- Lower the vehicle.
Install the fuel tank filler pipe fastener (1) and tighten to 9 N.m (80 lb in).
- Install the right rear wheelhouse panel liner. Refer to Rear Wheelhouse Liner Replacement .
- Install the right rear tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
- Fill the fuel tank.
- Install the fuel cap.
CAUTION:
Refer to Fastener Caution .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.