Circuit/System Verification

2019 Chevrolet Trax Premier, AWDSECTION Circuit/System Verification
WARNING: This page is about a different car, the 2018 Chevrolet Trax and 2018 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.
  1. Verify that no DTCs are set, except DTC P158A.
    • Go to next step: If only DTC P158A is setΒ 
  2. Reprogram the K9 Body Control Module and the K20 Engine Control Module one after the other. Do not place the Ignition On/Vehicle in Service Mode between each programming event.
  3. Verify DTC P158A does not set when operating the vehicle within the conditions for running the DTC.
    • Go to next step: If the DTC does not setΒ 
  4. All OK.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.