Outside Rearview Mirror Replacement

2019 Chevrolet Trax Premier, AWDSECTION Outside Rearview Mirror Replacement
WARNING: This page is about a different car, the 2018 Chevrolet Trax and 2018 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.
GM2780045
Callout Component Name
Preliminary Procedure Remove the front side door trim. Refer to Front Side Door Trim Replacement (Buick)Front Side Door Trim Replacement (Chevrolet) .
1 Outside Rearview Mirror Locator
NOTE:

When install the outside rearview mirror align the locator pin to the door hole.

2 Outside Rearview Mirror Nuts (Qty: 3)
CAUTION:

Refer to Fastener Caution .

Procedure

  1. Remove the water deflector to access the nuts.
  2. Disconnect the electrical connector.

Tighten 
9 N.m (80 lb in)
3 Outside Rearview Mirror
Procedure 
Inspect the outside mirror for proper operation before installing the door trim.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.